Synology DiskStation User Manual page 180

8 Click
the screen on the right.
9 Click
Note:
1 The level of sensitivity determines whether a camera is quick to respond to slight motion and start recording. You
can reach this by setting a high value for detection sensitivity, and a low value on threshold, object size, and trigger
percentage.
2 For IP cameras with the video format of MPEG4, if you want to schedule
only choose
3 You can setup maximum 10 detection areas.
To edit the guard settings:
1 Select the camera you want to edit, click Guard, and choose
setup. You can also click
schedule..
2 To setup preset position manually:
a In
b Name the preset position.
c Adjust the camera's focus by using the PTZ panel.
d Click
3 To setup patrol among several preset positions:
a In
b Name the patrol.
c In the
sequence by clicking
d Select
e Click
f Click
4 To setup guard by scheduling the patrols:
a In
b Select the trigger event among Continuous,
c Set up the action plan by selecting the patrol items and
in the previous step, select the interval between each cycle.
d Click or drag a time range on the schedule grid. To select the entire day or hour in each day, click the day
grid or the hour grid.
e Repeat the steps to add other patrol settings onto the schedule.
f If you want to cancel selection, click
g Click
h Click Close.
i You can also click
Note:
To remove cameras:
Choose the cameras you want to remove (press and hold Shift or Ctrl while making multiple selections), and click
Delete.
Note:
To disable cameras:
Choose the cameras you want to disable (press and hold Shift or Ctrl while making multiple selections), and click
Disable
180 Chapter 14: Safeguard Your Environment with Surveillance Station
Downloaded from www.Manualslib.com
Apply and Yes to apply the settings into camera or Surveillance Station. You can preview the changes in
Close to finish.
Motion detection by the camera
Guard and choose
Preset Position tab, click Add.
Save to save the preset position settings.
Patrol tab, click Add on the left section.
Preset positions list, click
Up or Down.
interval to indicate the time a camera should stay on each preset position.
Preview to preview patrol.
Save to save the settings or click
Guard tab, select the patrol from the drop-down menu.
Save to save the changes. Or you can click
Guard and choose
Preset position, patrol, and guard are only available to cameras that support the functions.
Removing cameras will remove both the camera settings and recorded videos.
in the Enable drop-down menu. Doing so will not delete the camera settings and recorded videos.
manuals search engine
to define the motion detection area.
Settings
Wizard from the drop-down menu to quickly set the guard
Add to add preset positions into patrol. Adjust the preset positions'
Reset to clear the settings.
Motion Detection, Alarm, or
Loops per
Delete and click the grid you want to cancel selection.
Reset to clear all settings.
Wizard from the drop-down menu to quickly set the guard schedule.
Synology DiskStation User's Guide
Based on DSM 3.1
Motion Detection Recording, you can
from the drop-down menu for manual
Motion Detection and
cycle. If you choose Continuous
Alarm.
mode