Advertisement
Quick Links
Advertisement
Related Manuals for Synology DiskStation Series
Summary of Contents for Synology DiskStation Series
- Page 1 RAM Module Quick Installation Guide...
- Page 2 DiskStation memory expansion. Follow the steps below for installation. Add a RAM Module on Synology DiskStation 1 Shut down your Synology DiskStation. Disconnect all cables connected to Synology DiskStation to prevent any possible damages. 2 Remove the 5 screws that secure the top case. Lift off the case and place it to the side.
- Page 3 b Tilt the card and push the memory into the slot. Make sure the module is pushed in all the way. c Use two fingers with firm, even pressure to push down on the memory module. You should hear a click when the memory is inserted correctly.
- Page 4 Make Sure Synology DiskStation Recognizes the New Memory Capacity After installing the memory module on your Synology DiskStation, it’s recommended that you check whether the server recognizes the new memory. To check Synology DiskStation’s memory: 1 Start up your Synology DiskStation.
- Page 5 Remove a RAM Module from Synology DiskStation 1 Follow step 1 and 2 of the “Add a RAM Module on Synology DiskStation” section to remove the case of Synology DiskStation. 2 Push the levers on the sides of the memory module in an outward direction to release the module from the memory card slot.
- Page 6 SYNOLOGY INC. www.synology.com Copyright © 2010 Synology Inc. All rights reserved. Synology, the Synology logo, and other names of Synology Products are proprietary marks or registered trademarks of Synology Inc. RAM01052010 Printed in Taiwan P/N: 15-06D010040...