Near Distance Tracking Test Procedure; Shim Adjustment To 75Mm Accessory Viewfinder - Polaroid 600SE Repair Manual

Turn distance scale with your finger, until scale reading agrees with measured distance.
Tighten lockscrew. If additional adjustment is required, insert shim under mounting base
as shown in Figure 5-16.
Figure 5-16. Shim adjustment to 75mm accessory viewfinder
e. Take an aiming photograph as previously described. Scribe lines and determine if error
has been corrected, as shown in Figure 5-12.
Near Distance Tracking Test
1. Mount the camera on a tripod at the same distance as used in the aiming and framing tests
(Figure 5-17).
Lens
127mm
150mm
75mm
2. Look through the RF/VF eyepiece. Adjust the lens barrel focusing ring to obtain perfect
coincidence of the vertical tape at the center of The Reporter aiming and framing target
No. ECR-12261. Mark with a pencil the distance scale of each lens as shown in Figure 5-18.
Note: Do not move tripod or camera, until collimation test is completed.
Plate
Suggested Distance
80.5 inches (2 meters)
96 inches (2.5 meters)
44 inches (1.2 meters)
87
Shim Location
Mounting Base