Disassembly/Assembly Procedures; General - Polaroid 600SE Repair Manual

4- Disassembly and Assembly

General

Disassembly and reassembly of both the model 600 and 600SE cameras is covered in this
section. Instructions apply to both models unless otherwise indicated. The differences between
model 600 and model 600SE camera are covered in Section 1.
The disassembly and repair of the film holder is covered at the end of this section. The film holder
can easily be removed from the camera by unlocking two sliding locks on the side of the camera.
The lens assemblies for the model 600SE camera are removable and interchangeable.
A lens can be easily removed by pushing the lens release button and rotating the lens
counterclockwise (Figure 4-1).
Lens Release Button
Film Holder Lock
Figure 4-1. Removing film holder and lens assembly, model 600SE camera
The lens assembly for the model 600 camera should be removed for repair or replacement only.
Instructions are included for the replacement of the shutter assemblies. Detailed disassembly of
the shutter assembly components are not included in the manual.
Screws, light seals and some other parts are glued into position. Use trichlorethylene to free
screw threads and to dissolve or remove glue. Use Pliobond adhesive to glue parts at
reassembly. Use Molycote or Lubriplate to lubricate parts as required.
29