Decode Session Timeout; Timeout Between Decodes, Same Symbol - Motorola DS6708 Product Reference Manual

Decode Session Timeout

Parameter # 88h
This parameter sets the maximum time decode processing continues during a scan attempt. It is
programmable in 0.1 second increments from 0.5 to 9.9 seconds. The default timeout is 9.9 seconds.
To set a Decode Session Timeout, scan the bar code below. Next, scan two numeric bar codes from
D, Numeric Bar Codes
For example, to set a Decode Session Timeout of 0.5 seconds, scan the bar code below, then scan the 0 and
5 bar codes. To correct an error or change the selection, scan Cancel on
Decode Session Timeout

Timeout Between Decodes, Same Symbol

Parameter # 89h
Use this option in presentation (scanstand) mode to prevent the beeper from continuously beeping when a
symbol is left in the digital scanner's field of view. The bar code must be out of the field of view for the timeout
period before the scanner reads the same consecutive symbol. It is programmable in 0.1 second increments
from 0.0 to 9.9 seconds. The default interval is 0.6 seconds.
To select the timeout between decodes for the same symbol, scan the bar code below, then scan two numeric
bar codes from Appendix D, Numeric Bar Codes
increments.
User Preferences & Miscellaneous Digital Scanner Options 4 - 15
that correspond to the desired on time. Enter a leading zero for single digit numbers.
page
that correspond to the desired interval, in 0.1 second
Timeout Between Decodes, Same Symbol
Appendix
D-2.