Decode Session Timeout; Timeout Between Decodes, Same Symbol - Motorola DS9208 Product Reference Manual

Decode Session Timeout

Parameter # 136
This parameter sets the maximum time decode processing continues during a scan attempt. It is
programmable in 0.1 second increments from 0.5 to 9.9 seconds. The default timeout is 9.9 seconds.
To set a Decode Session Timeout, scan the bar code below. Next, scan two numeric bar codes from
G, Numeric Bar Codes
For example, to set a Decode Session Timeout of 0.5 seconds, scan the bar code below, then scan the 0 and
5 bar codes. To correct an error or change the selection, scan Cancel on
NOTE The Decode Session Timeout cannot be less than or equal to either
Symbol

Decode Session Timeout

Timeout Between Decodes, Same Symbol

Parameter # 137
Use this option in presentation mode and
beeping when a symbol is left in the digital scanner's field of view. It is programmable in 0.1 second increments
from 0.0 to 9.9 seconds. The default interval is 0.4 seconds.
To select the timeout between decodes for the same symbol, scan the bar code below, then scan two numeric
bar codes from Appendix G, Numeric Bar Codes
increments.
NOTE The Timeout between Decodes, Same Symbol cannot be greater than or equal to the
Timeout.
that correspond to the desired on time. Enter a leading zero for single digit numbers.
or Timeout Between Decodes, Different
Continuous Bar Code Read
User Preferences & Miscellaneous Options 4 - 25
page
Symbols.
to prevent the beeper from continuously
that correspond to the desired interval, in 0.1 second

Timeout Between Decodes, Same Symbol

Appendix
G-2.
Timeout Between Decodes, Same
Decode Session