Smaw (Stick) Welding; Stick With S-Series User Interface - Lincoln Electric POWER WAVE S500 Service Manual

A-7
WORK CLAMP
INSTALLATION

SMAW (STICK) WELDING

Similar to TIG welding a user interface is required for
adjusting the Stick welding settings. A Power Feed
wire feeder can be used as the user interface or a
K3001-2 (user interface control panel) can be installed
into the power source (Figure A.3). The connection dia-
gram shown is based on the S-Series user interface
(K3001-2). In this diagram the remote control box is
optional.
FIGURE A.3

STICK WITH S-SERIES USER INTERFACE

USER INTERFACE
CONTROL PANEL
K3001-2
TO NEGATIVE (-) STUD
TO POSITIVE (+) STUD
WORK PIECE
POWER WAVE
TO REMOTE CONTROL
RECEPTACLE
ELECTRODE HOLDER KIT
K2394-1 KIT
(INICLUDES GROUND CLAMP)
® S500
A-7
REMOTE CONTROL BOX
K857