Connection Diagrams; Gtaw (Tig) Welding; Tig With S-Series User Interface - Lincoln Electric POWER WAVE S500 Service Manual

A-6
REGULATOR
FLOWMETER
GAS H H OSE
GAS S S OLENOID K K IT IT
(INSIDE M M ACH CHINE)
K282 825-1
INSTALLATION

CONNECTION DIAGRAMS

GTAW (TIG) WELDING

A user interface is required for adjusting the TIG weld-
ing settings. S-series user interface (K3001-2) can be
installed into the power source (Figure A.2). Refer to
the connection diagrams based on the user interface
that is being used. Alternate configurations are possi-
ble depending on the wire feeder that is being used.
Refer to the wire feederʼs manual for alternative con-
figurations.
FIGURE A.2

TIG WITH S-SERIES USER INTERFACE

TO N N EGATIVE
TIG T T ORC RCH
K2266-1 K K IT
(INC NCLUD UDES ES W W ORK C C LAMP,
ADAP APTER, A A ND ND R R EGULATOR)
POWER WAVE
USE SER I INTERFACE
CONTROL PA PANEL
K30 3001 01-2
TO R R EMOTE C C ONTROL
RECEP EPTACLE
TO P P OSITIVE VE ( ( +) S S TUD
VE ( ( -) S S TUD
WORK C C LAMP
® S500
A-6
FOOT A A MPTROL
K87 870
WORK P P IECE