Adjusting The Time Correction; Storing The Sound Field Adjustment Settings; Recalling The Stored Sound Field Adjustment Settings - Alpine CDA-137EBT Owner's Manual

2
Turn the Rotary encoder to adjust the level.
Adjustable level: -6 to +6 dB
3
To adjust another band, repeat steps 1 and 2, and then
adjust all bands.

Adjusting the Time Correction

Before performing the following procedures, refer to "About Time
Correction" on page 38.
1
After selecting T.Correction from the Sound Field mode,
press BAND to select a speaker to be adjusted.
*1 *2 *3 *4
F-L d F-R d R-L d R-R
*1 Front-L (Initial setting)
*2 Front-R
*3 Rear-L
*4 Rear-R
2
Turn the Rotary encoder to adjust the distance correction
value (0.0 to 336.6cm).
L = (distance to farthest speaker) - (distance to other speakers)
3
Repeat steps 1 and 2 to set another speaker.
By setting these values to make its sound reach the listening position
at the same time as the sound of other speakers.
Note
The total adjustment distance for all speakers should be less than 680cm
•
(268.1 inch).

Storing the Sound Field Adjustment Settings

The Sound Field Settings containing Parametric EQ/Graphic EQ and
T.Correction settings can be stored in the preset memory.
1
When the settings of Sound Field have been completed,
select any one of the preset buttons (1 through 6) in any
item of the Sound Field mode (e.g. Parametric EQ), press and
hold the desired preset buttons for at least 2 seconds.
2
Turn the Rotary encoder to select Protect YES/NO, and then
press s/ENTER to store the adjusted contents.
Protect YES (Initial setting) s Protect NO
Note
• If YES is selected, the adjusted contents are protected and stored into the
preset buttons. When you want to store the parameter into a protected
preset button, "Replace NO/YES" can be selected.
• If NO is selected, the preset is stored.
While perform this operation, all adjusted contents of Parametric EQ/
•
Graphic EQ and T.Correction will be stored in the preset buttons.
• The stored contents are not deleted even when resetting the unit or
disconnecting the battery.
• The stored contents can be recalled by performing operation (refer to
"Recalling the Stored Sound Field Adjustment Settings" on page 15).
d SW-L d SW-R d F-L
Recalling the Stored Sound Field Adjustment
Settings
The stored Sound Field Settings contain Parametric EQ/Graphic EQ and
T.Correction settings that are stored in the preset memory.
1
After selecting any item of the Sound Field mode (e.g.
Parametric EQ), press any one of the preset buttons (1
through 6) that has your desired characteristic in memory
to recall the stored settings.
2
Press the preset buttons (1 through 6) again to return to
the Sound Field mode.
Note
While performing this operation, all adjustment contents of Parametric
•
EQ/Graphic EQ and T.Correction stored in the preset buttons will be
recalled.
15
-EN