xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
The LLDP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following
table:
Command
enable lldp
disable lldp
config lldp
message_tx_interval
config lldp
message_tx_hold_multiplier
config lldp tx_delay
config lldp reinit_delay
config lldp
notification_interval
config lldp ports
config lldp ports
config lldp ports
config lldp ports
config lldp ports
config lldp ports
config lldp ports
config lldp ports
config lldp ports
config lldp
forward_message
show lldp
show lldp mgt_addr
show lldp ports
show lldp local_ports
show lldp remote_ports
Parameters
<sec 5 - 32768 >
< int 2 - 10 >
< sec 1 - 8192 >
< sec 1 - 10 >
<sec 5 - 3600 >
[<portlist>|all] notification [enable | disable]
[<portlist>|all] admin_status [tx_only | rx_only | tx_and_rx |
disable]
[<portlist>|all] mgt_addr ipv4 <ipaddr> [enable | disable]
[<portlist>|all] basic_tlvs [all | {port_description |
system_name | system_description | system_capabilities}]
[enable | disable]
[<portlist>|all] dot1_tlv_pvid [enable | disable]
[<portlist>|all] dot1_tlv_protocol_vid [vlan [all | <vlan_name
32> ] | vlanid <vlanid_list> ] [enable | disable]
[<portlist>|all] dot1_tlv_vlan_name [vlan [all | <vlan_name
32> ] | vlanid <vlanid_list> ] [enable | disable]
[<portlist>|all] dot1_tlv_ protocol_identity [all | { eapol | lacp
| gvrp | stp }] [enable | disable]
[<portlist>|all] dot3_tlvs [all |
{mac_phy_configuration_status | link aggregation |
power_via_mdi | maximum_frame_size}] [enable | disable]
[enable | disable]
{ipv4 <ipaddr>}
{<portlist>}
{<portlist>} {mode [brief | normal | detailed]}
{<portlist>} {mode [brief | normal | detailed]}
354
44
LLDP C
OMMANDS