Getting Started; Accessories; Set The Voltage Selector Switch; How To Put Batteries In The Remote Control - JVC MX-V508T Instruction Manual

Getting Started

Accessories

Check that you have all of the following items, which are supplied with the System.
AC Plug Adaptor (except for Hong Kong and China) (1)
Remote Control (1)
Batteries (2)
AM Loop Antenna (1)
FM Wire Antenna (1)
Video Cord (1)
If any of these items is missing, please contact your dealer immediately.

Set the VOLTAGE SELECTOR Switch

To avoid damaging the System, set the voltage before plugging the Unit into an AC power outlet.
• Set the correct voltage for your area with the VOLTAGE SELECTOR switch on the back panel of the
System. Use a screwdriver to turn the selector so that the arrow is pointed to the voltage in your area.
How To Put Batteries In the Remote
Control
The Remote Control requires 2 dry batteries which are supplied. Remove the rear lid of the Remote Control
by sliding it out in the direction of the arrow. Insert the batteries by matching the polarity (+ and –) on the
batteries with the + and - markings in the battery compartment.
Caution: Handle batteries properly.
To avoid battery leakage or explosion:
• Remove batteries when the Remote Control will not be used for a long time.
• Remove used batteries and replace both batteries at the same time with new ones.
• Don't use an old battery with a new one.
• Don't use different types of batteries together.

Using the Remote Control

The Remote Control enables you to control many functions of the System from a distance of up to 7m
(23feet) away.
When using the Remote Control, point the Remote Control at the remote sensor on the System's front panel.
Remote sensor
R6P (SUM-3)/AA (15F)
REPEAT
DISC
RANDOM
DISC
NTSC / PAL
/ PAL AUTO
DISC
SELECT
3