Table of Contents
Advertisement
Connection Notes
¢
Before you plug in the system, you must make all the necessary
connections.
Connecting the Two stereo Components
*
Connect the Amplifier/Tape Deck component and the Tuner/CD Auto-
matic Changer component.
Connect the two ribbon cables (CONNECTOR A and B) from Tuner/CD
Automatic Changer component to the Amplifier/Tape Deck component.
Connecting The Speakers
Speaker Terminals
Connect the speakers to the Amplifier/Tape Deck components as follows:
1. When connecting speakers, open each terminal and Insertthe end
of the speaker wire as shown.
:
2. Close. the terminals as shown to clamp the speaker wires In place.
SPEAKERS
Connect the Speakers to the SPEAKERS terminal on the Amplifier/Tape
Deck as follows.
;
3. Connect the (+) and (-) terminals of the right-side Speaker to the
(+) and (~) terminals marked RIGHT on the Amplifler/Tape Deck.
4. Connect the (+) and (-) terminals of the left-side Speaker to the (+)
and (—) terminals marked LEFT on the Amplifier/Tape Deck.
«
Using speakers with the correct impedance. The correct impedance Is
indicated on the rear panel.
The amplifier can also be connected to a Turntable (PHONO), a Video
Cassette Recorder (VCR) and a Digital Audio Tape (DAT) Deck.
If you connect a turntable, connect the ground wire from the turntable to the
AM antenna GND terminal.
Mv UT
THT,
6
8 (No. 20342)
Advertisement
Table of Contents
