Konica Minolta bizhub pro C6500P User Manual page 346

3
4
Load the desired size of paper to be adjusted on a tray, specify the set
number to 10, then press [Start] on the control panel.
A sample pattern will be output.
5
Check the diameter of penetrated holes when output sheets are piled
up.
6
If the desired result cannot be obtained, touch [ADJUSTMENT] tab.
The Paper Width Adjustment Screen will be restored.
7
Display the required size key using up/down arrow keys, and touch it.
8
Use the touch panel keypad to enter the desired adjustment value, then
touch [<<SET].
Available range: -20 (wide) to +20 (narrow), 1 step = 0.1 mm
9
Repeat the adjustment steps from 3 to 8 until the desired result is ob-
tained.
10
Touch [Return] to restore the Adjustment Menu Screen.
Note
If the setting is too wide, the center position of punch holes may dislo-
cate. If the setting is too narrow, the position of punch holes may vary.
3-24
Adjustment
bizhub PRO C6500P