Vehicle Inspection; Shift Link Rod Inspection; Throttle Inspection - Polaris A12MH46AX Service Manual

MAINTENANCE

VEHICLE INSPECTION

Shift Link Rod Inspection

NOTE: Shift rod is preset at time of manufacturer.
1. Lubricate pivot points with a light aerosol lubricant or
grease if desired.
Shift Link Rod
Shifter
2.12
Shift Mount
9923412 - 2012 Sportsman 400/500 and EFI Tractor Service Manual
© Copyright 2011 Polaris Sales Inc.

Throttle Inspection

Check for smooth throttle opening and closing in all
handlebar positions. Throttle lever operation should be
smooth and lever must return freely without binding.
1. Place the gear selector in Park.
2. Set parking brake.
3. Start the engine and let it idle.
4. Turn handlebars from full right to full left. If idle speed
increases at any point in the turning range, inspect
throttle cable routing and condition. Adjust cable
tension as needed until lock-to-lock turning can be
accomplished with no rise in engine rpm.
5. Replace the throttle cable if worn, kinked, or
damaged.
3
6
III. 1
To remove the ETC cover:
1. Use a medium flat blade screwdriver and insert blade
into the pocket of the cover starting on the #1
position.
2. Twist screwdriver slightly while lifting on the cover to
release snap.
3. Repeat procedure at the other five locations as
shown.
NOTE: Do not attempt to remove cover until all latch
points are released.
2
1
5
4
ETC Cover
Removal Sequence