Installation - Polaris A12MH46AX Service Manual

FINAL DRIVE
3. Pull sharply outward
transmission. Install a new compression ring and
apply an anti-sieze compound to the splines upon
assembly.
Pull outward sharply to remove
from transmission

Installation

1. Apply anti-seize compound to splines of shaft.
2. Install a new lock ring and install the inner shaft.
3. Slide shaft assembly into the bearing carrier hub.
7.38
to remove shaft
Compression Ring
9923412 - 2012 Sportsman 400/500 and EFI Tractor Service Manual
© Copyright 2011 Polaris Sales Inc.
from 4. Lift bearing carrier into place and install bolt to upper
control arm. Torque bolt to specification.
Upper Hub Carrier Bolt Torque:
5. Install hub, flat washer, domed washer (domed side
out) and nut. Torque center hub nut to specification.
Install new cotter pin and hub cap.
6. Install brake caliper and tighten bolts to specification.
Refer to Chapter 9.
7. Install rear wheel and torque wheel nuts to
specification.
Steel Wheels - 27 ft. lbs. (37 Nm)
Aluminum Wheels - 30 ft. lbs. + 1/4 turn (41 Nm
8. Grease all fittings thoroughly with Premium U-Joint
Lubricant (PN 2871551).
= T
37 ft. lbs. (50 Nm)
= T
Rear Hub Nut Torque:
80 ft. lbs. (109 Nm)
80 ft.lbs. (109 Nm)
= T
Wheel Nut Torque:
+ 1/4 turn