Toe Alignment Adjustment; Exhaust Pipe - Polaris A12MH46AX Service Manual

MAINTENANCE

Toe Alignment Adjustment

If toe alignment is incorrect, measure the distance
between vehicle center and each wheel. This will tell you
which tie rod needs adjusting. NOTE: Be sure handlebars
are straight ahead before determining which tie rod(s)
need adjustment.
CAUTION
During tie rod adjustment, it is very important that the
following precautions be taken when tightening tie
rod end jam nuts. If the rod end is positioned
incorrectly it will not pivot, and may break
Hold
Rod End
Correctly
Tightened
Jam Nut
III. 2
To adjust toe alignment:
• Hold tie rod end to keep it from rotating.
• Loosen jam nuts at both end of the tie rod.
• Shorten or lengthen the tie rod until alignment is as
required to achieve the proper toe setting as
specified.
• IMPORTANT: When tightening the tie rod end jam
nuts, the rod ends must be held parallel to prevent
rod end damage and premature wear. Damage
may not be immediately apparent if done
incorrectly. See illustration 2.
• After alignment is complete, torque jam nuts to
specification.
Tie Rod Jam Nut Torque:
12-14 ft. lbs. (16-19 Nm)
2.26
Incorrectly
Tightened
Jam Nut
= T
9923412 - 2012 Sportsman 400/500 and EFI Tractor Service Manual
© Copyright 2011 Polaris Sales Inc.

Exhaust Pipe

WARNING
• Do not perform clean out immediately after
the engine has been run, as the exhaust
system becomes very hot. Serious burns
could result from contact with exhaust
components.
• To reduce fire hazard, make sure that there
are no combustible materials in the area
when purging the spark arrestor.
• Wear eye protection.
• Do not stand behind or in front of the vehicle
while purging the carbon from the spark
arrestor.
• Never run the engine in an enclosed
area.Exhaust contains poisonous carbon
monoxide gas.
• Do not go under the machine while it is
inclined.Set the hand brake and block the
wheels to prevent roll back.
Failure to heed these warnings could result in
serious personal injury or death.
The exhaust pipe must be periodically purged of
accumulated carbon as follows:
1. Remove the clean out plugs located on the bottom of
the muffler.
III. 1
2. Place the transmission in Park and start the engine.
Purge accumulated carbon from the system by
momentarily revving the engine several times.
Clean Out Plug