Yamaha MOTIF XF Reference Manual page 142

Song Playback
Swing Rate
Delays notes on even-numbered beats (backbeats) to
produce a swing feel. Settings above 50% will delay notes to
produce a more pronounced swing feel.
Settings:
Quantize Value
When the Quantize Value is set to off
When the Quantize Value is set to 32nd note
When the Quantize Value is set to 16th note triplet
When the Quantize Value is set to 16th note
When the Quantize Value is set to 8th note triplet
When the Quantize Value is set to 8th note
When the Quantize Value is set to 1/4 note triplet
When the Quantize Value is set to 1/4 note
Note Shift*
Raises or lowers the pitch of all notes in the selected track
in semitones.
Settings: -99 – +0 – +99
Clock Shift
Shifts the timing of all notes in the selected track forward or
backward in clock increments.
Settings: -120 – +0 – +120
Gate Time Rate
Raises or lowers the gate time of all notes in the selected
track. If an adjusted gate time value is less than 1, the
value is rounded off to 1.
Settings: 0% – 100% – 200%
Velocity
Raises or lowers the velocity of all notes in the selected
track. If the result is 0 or less, the value is set to 1. If the
result is higher than 127, the value is set to 127.
Velocity Rate
Alters the velocity of notes by the specified percentage.
Settings: 0% – 100% – 200%
Velocity Offset
Increases or decreases the velocity of notes by the specified
offset value.
Settings: -99 – +0 – +99
[SF6] INFO (Information)
You can view the amount of free and used sequencer
memory. The sequencer memory covers all Songs and
Patterns recorded in the respective modes. When the used
memory amount reaches the maximum capacity, no further
Songs or Patterns can be stored. If this occurs, use the
Clear Song Job (page 165) or Clear Pattern Job
(page 187) to delete any unnecessary Songs or Patterns.
You can go back to the previous display by pressing the
[SF6] button or the [EXIT] button.
142
MOTIF XF Reference Manual
Output Channels and Loop settings
for each track—[F3] Track
This display lets you set the Output Channel and set the
Settings
Loop Playback related parameters for each track.
0 – 0
0 – 30
0 – 40
Track Channel Settings—[SF1] Out
0 – 60
(Output Channel)
0 – 80
0 – 120
0 – 160
This display lets you set the MIDI Transmit Channel for
0 – 240
each track.
Voice (Indication only)
Indicates the Voice name of the Mixing Part corresponding
to each track.
n In the Part 1 – 16 display (page 190) of the Mixing mode, you
can change the Voice of the Mixing Part corresponding to the
track.
TxCh (Transmit Channel)
Determines the MIDI transmit channel of the sequence
data for each track. Tracks set to "off" will not sound. In the
Song mode, the MIDI data created by playing the
keyboard/knobs/wheels is sent to the tone generator block
or the external MIDI devices via the MIDI output channel of
the currently selected track.
Settings: 1 – 16, off
Int (Internal Switch)
Determines whether musical performance data of each
track is sent to the internal tone generator block or not.
When set to "off," the performance data will not be sent to
the internal tone generator block.
Ext (External Switch)
Determines whether performance data of each track is
sent to the external MIDI device or not. When set to "off,"
the performance data will not be sent to the external MIDI
device.