Extract - Yamaha MOTIF XF Reference Manual

Waveform as source
Waveform as destination
Determines the copy source and destination Waveform
numbers.
NOTICE
This operation overwrites any data previously existing at the
destination Waveform number.
02: Delete
This Job lets you delete a specific Waveform from memory.
The Key Banks and Samples included in the Waveform are
also deleted.
Waveform
Determines the Waveform number to be deleted.

03: Extract

This Job lets you delete all unnecessary parts of the
Sample (located ahead of the Start Point and located after
the End Point).
Start point End point
Waveform
Determines the Waveform number to be extracted.
04: Transpose
This Job lets you transpose the Key Bank setting of a
specified Waveform in semitones or in octaves.
Waveform
Determines the Waveform number to which this Job is
applied.
Octave
Determines the amount in octaves by which the Key Bank is
transposed. When you want to transpose by less than one
octave, set this to "0" and use the Note parameter below.
Settings: -3 – +0 – +3
Start point End point
Extract
Creating a Voice/Performance by Using the Sampling Function
Note
Determines the amount in semitones by which the Key Bank is
transposed. When you want to transpose by exact octaves,
set this to "0" and use the Octave parameter above.
Settings: -11 – +0 – +11
05: Rename
This Job lets you assign a name to the selected Waveform.
Waveform
Determines the Waveform number to which this Job is
applied.
Name
Determines the Waveform name which can contain up to
10 characters. For detailed instructions on naming, refer to
"Basic Operation" on page 37.
[F3] Other Jobs
01: Optimize Memory
This Job optimizes the memory (SDRAM) for Sampling.
Optimization consolidates areas of used and unused
(available) memory to create the largest possible area of
contiguous available memory. In some cases, the amount
of remaining memory will be increased when you execute
the Optimize Memory Job.
02: Delete All
This Job deletes all the user Waveforms. The Key Banks
and Samples included in the Waveform are also deleted.
03: Copy to Flash Memory
This Job copies the Sample data on SDRAM to the optional
Flash Memory Expansion Module (FL512M/FL1024M) as
Waveforms.
MOTIF XF Reference Manual
135