Yamaha MOTIF XF Reference Manual page 106

Editing a Performance
Audio In settings—[F4] Audio In
You can set parameters related to audio input from the A/D
INPUT connector and the IEEE1394 connector.
n The FW settings (FW1 –14) are available only when the
optional FW16E is installed.
Output Settings—[SF1] Output
Volume
Determines the output level of the Audio Input Part.
Settings: 0 – 127
Pan
Determines the stereo pan position of the Audio Input Part.
Settings: L63 (far left) – C (center) – R63 (far right)
Mono/Stereo
Determines the signal configuration for the Audio Input Part,
or how the signal or signals are routed (stereo or mono).
Settings: L mono, R mono, L+R mono, stereo
L mono
Only the L channel of the audio input is used.
R mono
Only the R channel of the audio input is used.
L+R mono
The L and R channels of the audio input are mixed and processed in
mono.
stereo
Both the L and R channels of the audio input are used.
Output Select
Determines the output jack assignment for the Audio Input
Part.
Settings: See the table below.
LCD Output jacks
L&R OUTPUT L and R
asL&R ASSIGNABLE OUTPUT L and R
FW1&2 FW OUTPUT 1 and 2
FW3&4 FW OUTPUT 3 and 4
FW5&6 FW OUTPUT 5 and 6
FW7&8 FW OUTPUT 7 and 8
FW9&10 FW OUTPUT 9 and 10
FW11&12 FW OUTPUT 11 and 12
FW13&14 FW OUTPUT 13 and 14
asL ASSIGNABLE OUTPUT L
asR ASSIGNABLE OUTPUT R
106
MOTIF XF Reference Manual
FW1
FW14
ins L
(A/D input only)
n You can call up the list and select the desired item by pressing
Reverb Send
Determines the Send level of the Audio Input Part signal
sent to the Reverb effect. The higher the value, the deeper
the reverb.
Settings: 0 – 127
Chorus Send
Determines the Send level of the Audio Input Part signal
sent to the Chorus effect. The higher the value, the deeper
the Chorus.
Settings: 0 – 127
Dry Level
Determines the level of the Audio Input Part which has not
been processed with the System Effects (Reverb, Chorus).
The higher the value, the shallower the Reverb and Chorus.
Settings: 0 – 127
Insertion Effect Connection of A/D Input
—[SF2] Connect
From this display, you can set the Insertion Effect Types
applied to the Audio Input signal in the Performance mode.
The System Effect can be set in the Effect display
(page 107). Keep in mind that the Insertion Effect cannot
be applied to the audio input signal via the IEEE1394
connector.
Stereo/Mono
Stereo
Stereo
Stereo (1: L, 2: R)
Stereo (3: L, 4: R)
Stereo (5: L, 6: R)
Stereo (7: L, 8: R)
INSERTION CONNECT (Insertion Connection)
Stereo (9: L, 10: R)
From this display you can set the effect routing for Insertion
Stereo (11: L, 12: R)
effects A and B. The setting changes are shown on the
Stereo (13: L, 14: R)
diagram in the display, giving you a clear picture of how the
Mono signal is routed.
Mono Settings: Ins A F B, Ins B F A
LCD Output jacks
FW OUTPUT 1
: :
FW OUTPUT 14
Internal Vocoder Module
the [SF6] LIST button. For details, see page 37.
Stereo/Mono
Mono
:
Mono
Mono