Sony HXC-100 Operating Instructions Manual page 82

Locations and Functions of Parts
1 Control select block
A B
PARA MASTER SLAVE
A PARA (parallel mode) button
This button lights when Parallel mode is active, in
which concurrent operation with another control panel
is possible.
When this button is lit, all the buttons and controls on
this panel except for the iris/master black control block
are active, even if the PANEL ACTIVE button is not
lit.
If you press the button when lit, it goes dark and
Parallel mode is cancelled.
B MASTER and SLAVE buttons
When adjusting the white balance of multiple cameras
in Master/Slave mode, designate the master camera or
the slave cameras. Press and light up the MASTER
button to specify the connected camera for the master.
Press and light up the SLAVE button to specify the
connected camera for the slave. The slave cameras
follow the master camera settings.
If you press a button when lit, it goes dark.
2 STANDARD button
When you press this button, the video camera is
initialized to its standard state and the button lights for
several seconds.
If you press the button while it lights, the video camera
retrieves the state before the button was lit.
3 Camera/CCU function ON/OFF buttons
Various functions of the video camera or the CCU/
HDCU-series can be turned on and off from this panel.
CHAR
ACTER
5600K AUTO SKIN
KNEE DETAIL GATE
6(E)
DTL BLACK
GAMMA
5600K: 5600K electric color temperature conversion
function
AUTO KNEE: Auto knee function. When this button
is lit (ON), the knee point is automatically adjusted
according to the light content of the picture.
SKIN DETAIL: Skin tone detail function
DTL GATE: Skin tone detail gate function. When
this button is lit (ON), the adjustment range of the
skin tone detail is displayed in white on the PIX
(picture) monitor screen.
BLACK GAMMA: Black gamma function
CHARACTER: Self-diagnostic display function.
When this button is lit (ON), the contents of the
self-diagnosis of the CCU/HDCU-series are
displayed on the monitor connected to the
CHARACTER OUTPUT connector of the CCU/
HDCU-series. The contents are also mixed to the
video signal to be output from the PIX1 OUTPUT
connector. Each time you press this button, the
status changes as follows.
c c
OFF ON (page 1)
c c
ON (page n ) OFF
The contents of the self-diagnosis may be
displayed when required even if this button is not
lit.
The right two buttons are for future use and do not
function at present.
4 WHITE (white balance manual adjustment)
knobs
Used to manually adjust the white balance. From the
left, the knobs are for R, G, and B signal adjustment.
5 BLACK/FLARE (black balance/flare balance
manual adjustment) knobs and indicator
Used to manually adjust the black balance (when the
indicator is not lit) or the flare balance (when the
indicator is lit).
From the left, the knobs are for R, G, and B signal
adjustment.
Selection between black balance and flare balance is
made using the Maintenance menu.
See "Changing the Function of the Rotary Encoders" on
page 27(E).
ON (page 2) . . .