Sony HXC-100 Operating Instructions Manual page 60

Connection Speed: Connection speed setting
Duplex Mode: Communication method setting
MDI/MDIX: Communications port wiring configuration
selection
Link Status: Network connection status
Page 2
*N e t w o r k D i a g 2 / 3 *
CN S M o d e : B R I G D E
CC U N o . : 1
CNS Mode: REMOTE and LAN connectors mode setting
CCU No.: CCU number setting
Page 3
*N e t w o r k D i a g 3 / 3 *
IP A d d r e s s
0 . 0 . 0 . 0
Su b n e t M a s k
0 . 0 . 0 . 0
De f a u l t G a t e w a y
0 . 0 . 0 . 0
IP Address: CCU IP address setting
Subnet Mask: CCU subnet mask setting
Default Gateway: CCU default gateway setting
CCU SY board diagnostics
*S Y D i a g *
Re f e r e n c e : H D
HD - S D D e l a y : L i n e ( 9 0 H)
PL D S t a t u s : O K
S Y : 1 . 0 0
R E T : 1 . 0 0
SY P W R : O K V I F P W R :O K
Reference: Reference signal setting
HD-SD Delay: HD to SD delay setting
PLD Status: PLD status
PLD SY: SY-PLD version
PLD RET: RET-PLD version
SY PWR: SY board power supply status
VIF PWR: VIF board power supply status
7 /1 2
8 /1 2
9 /1 2
CCU DPR board diagnostics
* DPR Di ag * 1 0/1 2
H D C B : BA R 1 6:9 (1 00% )
S D C B : SM PTE
S EQ ON: NP N
P LD Sta tu s:O K
DE- MU X:1 .00
ANA LO G:1 .00
POS T :1 .00
MAP :1 .00
I IC :O K
D PR PWR :O K SDI P WR: OK
HD CB: HD color bar setting
SD CB: SD color bar setting
SEQ ON: SEQ ON polarity
PLD Status: PLD status
PLD DE-MUX: DEMUX-PLD version
PLD ANALOG: ANALOG-PLD version
PLD POST: POST-PLD version
PLD MAP: MAP-PLD version
IIC: IIC bus control status
DPR PWR: DPR board power supply status
SDI PWR: SDI board power supply status
Front panel diagnostics
This screen is displayed only when the HKCU-FP1 CCU
Control Panel is fitted.
* Fro nt Pa nel D iag * 11 /13
A ssi gna bl e/C ust om
SW1 :CA M P OW ER
SW2 :56 00K
VOL UME :SD DT L Lev el
S W B rig ht :Lo w
I IC :OK
Assignable/Custom SW1: Function assigned to the SW1
button
Assignable/Custom SW2: Function assigned to the SW2
button
Assignable/Custom VOLUME: Function assigned to the
CUSTOM knob
SW Bright: Button lights LED brightness setting
IIC: IIC bus control status
Camera hardware diagnostics
* CAM ERA D iag * 1 1/1 2
A LL BO ARD O K
Displays the camera hardware status.
17
Status Display