Connections & Installation (continued)
14
EN
Switch Settings (continued)
Machine ID Setting Switch
When controlling the system using a multi-drop remote
control unit such as RM-P2580, for instance, assign a
number (machine ID) for identification to each of the
connected cameras.
Assign a machine ID according to the video input number of
RM-P2580.
R Ceiling Mount (Setting Switch Side)
ON
1
2
3
4
5
6
7
8
Machine ID
<Procedures for Checking Machine ID>
Output video image for checking to the monitor
Turn on the power (AC 24 V) of the camera
Camera initializes
The following message will appear.
>>
INITIAL PROCESS
PAN : - - I - -
TILT : - - I - -
PROTCOL DUPLEX : ID-01
Check that this is displayed as
"DUPLEX"
Check to ensure that "DUPLEX" and ID-LL are
displayed, and whether the number coincides
with the video input number of RM-P2580. If the
number is incorrect, re-set the machine ID.
● For systems using RM-P2580, a set of control signal cables are
connected to multiple cameras during use. Errors in the switch
setting of any one of the cameras will therefore cause malfunction in
the entire system.
<<
Displayed as ID-LL. Check
that the number LL is correct.