Daikin Super Multi Plus E-Series Service Manual page 285

SiEN18-622
Press the AIR FLOW DIRECTION ADJUST button
to select the air direction as following.
The AIR FLOW FLAP display swings as
shown left and the air flow direction
continuously varies. (Automatic swing
setting)
swing
Press AIR FLOW DIRECTION ADJUST
button to select the air direction of your
choice.
The AIR FLOW FLAP display stops
swinging and the air flow direction is fixed
(Fixed air flow direction setting).
Movement of the air flow flap
For the following conditions, micro computer controls the air
flow direction so it may be different from the display.
Operation
Cooling
mode
• When room
temperature is
lower than the set
temperature
Operation
condition
• When operating
continuously at
horizontal air flow
direction
Operation mode includes automatic operation.
Program timer operation
Operate in the following order.
• The timer is operated in the following two ways.
• Programming the stop time (
operating after the set time has elapsed.
• Programming the start time (
operating after the set time has elapsed.
• The timer can be programmed maximum for 72 hours.
• The start and the stop time can be simultaneously
programmed.
System Configuration
Press the TIMER MODE START/STOP button several
times and select the mode on the display.
The display flashes.
For setting the timer stop .... "
For setting the timer start ... "
Press the PROGRAMMING TIME button and set the time
for stopping or starting the system.
Heating
• When room
temperature is
higher than the
set temperature
• At defrost
Press the TIMER ON/OFF button.
operation
The timer setting procedure ends.
The display "
a constant light.
NOTE
•
When the timer is programmed to stop the system after 3
) ... The system stops
hours and start the system after 4 hours, the system will stop
after 3 hours and then 1 hour later the system will start.
) ... The system starts
•
•
7. Optimum operation
Observe the following precautions to ensure the system
operates.
•
•
•
Ceiling Mounted Cassette Type
1
Timer mode START/STOP
2
Programming time
When this button is pressed, the time advances by
1 hour.
When this button is pressed, the time goes
backward by 1 hour.
3
Timer ON/OFF
or
Refer to figure 4 on page [1]
When setting the timer OFF and On at the same time,
repeat the above procedure from 1 to 3 once again.
After the timer is programmed, the display shows the
remaining time.
Press the TIMER ON/OFF button once again to cancel
programming. The display vanishes.
Adjust the room temperature properly for a comfortable
environment. Avoid excessive heating or cooling.
Prevent direct sunlight from entering a room during cooling
operation by using curtains or blinds.
Ventilate the room regularly.
Using the unit for long periods of time requires attentive
ventilation of the room.
"
"
" changes from flashing light to
273