Floppy Disk Drive (Fdd) - Toshiba Equium 5160D Series Preliminary Maintenance Manual

4. Secure the CD-ROM drive to its bracket with four (two on each side) screws.
5. Connect power cable P7, the data cable, and the audio cable to the CD-ROM drive .
6. Replace the computer's cover. (Refer to section 4.2.2.)
7. Connect the power cord and all external cables to the computer and turn on the power.

Floppy Disk Drive (FDD)

This section covers the removal and replacement of the computer's floppy disk drive.
Removing the FDD
To remove the computer's FDD, perform the following procedure and see Figures 4-20 and
4-21.
1. Turn off power to the computer, then disconnect the power cord and all external cables
connected to the computer.
2. Remove the computer's cover. (Refer to section 4.2.1.)
3. Disconnect the power cable and the data cable from the FDD.
Figure 4-20 Disconnecting and Connecting FDD Cables
NOTE: Because the FDD and the HDD are attached by a mounting bracket,
you must remove the cables from the HDD in order to remove the FDD from the
chassis.
1. Remove the power and the data cables from the HDD. (Refer to section 4.5.1.)
2. Remove the one screw that secures the FDD/HDD bracket to the chassis.
3. Gently push the FDD inward (toward the rear of the computer) through its face-plate
slot until movement is stopped by the hook tabs. Angle the back of the mounting
bracket and lift the bracket out of the chassis.
NOTE: If you are performing this procedure in order to remove the HDD, do
not perform the remaining step.
1. Remove the four (two on each side) M3 screws that secure the FDD to the mounting
bracket.
Equium™ Series Maintenance Manual --------------------------------------------------------- 4-24