Toshiba Equium 5160D Series Preliminary Maintenance Manual page 57

Turn off power to the computer before removing and inserting connectors or test
equipment.
Use tools and other equipment that are conductive.
Recommended Tools and Equipment
The following equipment is necessary to disassemble and assemble the computer:
Toshiba #1/#2 reversible magnetic screwdriver
Small, flat-bladed screw driver
Needle-nose pliers
ESD mats for the working area floor and table
An ESD wrist strap or heel grounder
Anti-static carpeting or flooring
Air ionizers in highly static-sensitive areas
Protective gloves
Cover and Rear Panel
This section covers the removal and replacement of the computer's cover and rear panel.
Removing the Cover
To remove the computer's cover, perform the following procedure and see Figure 4-11.
1. Turn off power to the computer, then disconnect the power cord and all external cables
connected to the computer.
2. Simultaneously press the release buttons on either side of the chassis and slide the
cover forward (assuming you are standing at the rear of the computer).
3. Remove the cover from the chassis.
Equium™ Series Maintenance Manual --------------------------------------------------------- 4-13
Figure 4-11 Removing and Replacing the Cover