Replacing the CD-ROM Drive
To replace the computer's CD-ROM drive, perform the following procedure and see Figure
4-17 through 4-19.
1. Verify that the device configuration jumper is set in the slave position.
Figure 4-19 Device Configuration Jumper and Mode Select Jumper Settings
2. Verify that the mode select jumper is set to enable CD-ROM ejection.
3. Slide the CD-ROM drive into its bracket, so that the drive rests on the bracket's
support tabs and the screw holes on the drive line up with the holes in the bracket.
Equium™ Series Maintenance Manual --------------------------------------------------------- 4-23