Bios Beep Codes; Pci Configuration Error Messages - Toshiba Equium 5160D Series Preliminary Maintenance Manual

Models 5160D and 5200D Error Messages and Beep Codes

BIOS Beep Codes

Table D-74 Models 5160D and 5200D BIOS Beep Codes
Beeps Error Message
1 Refresh Failure
2 Parity Error
3 Base 64 KB Memory Failure
4 Timer Not Operational
5 Processor Error
6 8042 - Gate A20 Failure
7 Processor Exception Interrupt
Error
8 Display Memory Read/Write
Error
9 ROM Checksum Error
10 CMOS Shutdown Register
Rd/Wrt Error

PCI Configuration Error Messages

The following PCI messages are displayed as a group with bus, device and function
information.
Table D-75 Models 5160D and 5200D PCI Configuration Error Messages (1/2)
Error Message
NVRAM Checksum Error, NVRAM
Cleared
System Board Device Resource
Conflict
Primary Output Device Not Found
Primary Input Device Not Found
Primary Boot Device Not Found
NVRAM Cleared By Jumper
TM
Equium Series Maintenance Manual------------------------------------------------------------ E-1
Description
The memory refresh circuitry on the system board is faulty.
Parity is not supported on this product, will not occur.
Memory failure in the first 64 KB.
Memory failure in the first 64 KB of memory, or Timer 1 on
the system board is not functioning.
The CPU on the system board generated an error.
The keyboard controller (8042) may be bad. The BIOS
cannot switch to protected mode.
The CPU generated an exception interrupt.
The system video adapter is either missing or its memory
is faulty. This is not a fatal error.
ROM checksum value does not match the value encoded
in BIOS.
The shutdown register for CMOS RAM failed.
Explanation
The ESCD data was reinitialized because of an NVRAM
checksum error. Try rerunning the ICU.
A non Plug and Play ISA card has requested a resource that is
already in use.
The designated primary output device (printer, modem, or
other, if output is redirected) could not be found.
The designated primary input device (keyboard, mouse, or
other, if input is redirected) could not be found.
The designated primary boot device (hard disk drive, diskette
drive, or CD-ROM drive) could not be found.
The "Clear CMOS" jumper has been moved to the "CLR"
position and CMOS RAM has been cleared.