Navigation System - Fiat Bravo User Manual

NAVIGATION SYSTEM

Problem
The display indicates:
INSERT USB MEMORY
WITH MAPS
The display indicates:
WAIT... NO GPS SIGNAL
Probable Cause
❒ No USB device is connected
❒ The USB device connected does not
contain map data
❒ The USB device is faulty or connected
incorrectly
❒ GPS signal reception could be hin-
dered if the car is located beneath
trees, among tall buildings, in covered
car parks or in tunnels.
❒ The battery has been disconnected
(e.g. during servicing).
❒ A system fault may have occurred or
the GPS aerial may have been discon-
nected.
Possible Solution
❒ Insert the USB connecting the
Blue&Me™ Nav maps in the USB
port.
❒ Check that the USB device in use the
same one received in the
Blue&Me™ Nav navigation set or
check that the maps for
Blue&Me™ Nav are loaded on the
USB device.
❒ Check the USB device is properly
connected.
❒ Check that the USB device used is
the same one included in the
Blue&Me™ Nav navigation set.
❒ Try to load the map data onto a new
USB device using the Blue&Me™
Nav Map Assistant software on
the map CD-ROM (see the
Blue&Me™ Nav Map Assistant
quick guide in the Blue&Me™ Nav
navigation set).
❒ Move the car to an open area where
the GPS signal reception is good, or
wait until the obstacle has passed if
the vehicle is moving.
❒ Wait at least 15 minutes to allow the
system to calculate the correct GPS
position again.
❒ Consult a Fiat dealer.
97