Rinnai V2532FFUC Manual page 35

I N S TA L L E R ’ S I N S TA L L AT I O N I N S T R U C T I O N S
1) Determine a suitable location for the
control.
2) Make three holes on the wall as
shown.
3) Run the cable between the control and
the Integrity V2532C or the control
and the other control.
4) Remove the face plate from the remote control, using a screw driver.
5) Connect the cable to the remote control.
6) Mount the control to the wall using the holes drilled in step 2.
Note: If the cable cannot be run in the wall cavity, the plastic knockout should be
removed from the top or bottom of the control to allow flush mounting with the
wall
7) Disconnect the power from the Integrity V2532C.
8) Remove the cover of the Integrity V2532C.
9) Remove the plastic cover from the PCB and electrical connections.
DO NOT ATTEMPT TO CONNECT THE REMOTE CONTROLS WITH THE POWER ON,
THERE'S 120 VOLT POTENTIAL, NEXT TO THE REMOTE CONTROL CONNECTIONS
INSIDE THE UNIT. All service and wiring should be performed by a certified installer.
10) Thread the cable through the
access hole at the base of the unit
and connect the wires to the
control terminals on the right hand
side bottom of the PCB.
11) Secure the control cable using the
clamp provided.
12) Replace plastic cover over PCB
and then replace the cover of the
Integrity V2532C.
Model V2532FFUC
Remote Control - Installation
3 5
outline of remote
securing screw
wire hole
securing screw
21/32 inch
1 1/16 inches
3 1/4 inches
www.rinnai.us