Device Settings - Brady BP-PR PLUS series Configuration Instructions

BP-PR PLUS series
Configuration
4.1.2

Device settings

1. Press the menu button.
2. Select Setup > Machine param..
Parameter
Printhead pos. X Shifting of the entire print image perpendicular to the direction of paper flow.
Printhead pos. Y Shifting of the entire print image in the direction of paper flow. With positive
Tear-off pos.
Demand sensor
Cutter
Applicator
Brightn. LCD
Contrast LCD
Time Powersave.
Debug mode
Tab. 9: Parameters of the menu Setup > Machine param.
22
Meaning
The absolute shifting of the print image perpendicular to the direction of
paper flow is limited to the difference between the label width and the print-
head width set in the software.
You can also set the Printhead pos. X via software. The offset values
from the Machine param. menu and the software are added together.
values, printing begins later in the direction of paper flow.
Shifting of the print image in the direction of paper flow also influences the
peel and cutting positions.
⇒ Correct the Peel position and Cut position parameters by the
same value in the opposite direction.
You can also set the Printhead pos. Y via software. The offset values
from the Machine param. menu and the software are added together.
Shifting of the tear-off position in the direction of paper flow. With positive
values, the label strip is transported farther out of the printer.
Configuration of the optional peel-off module. See documentation of the peel-off module.
If peel-off module is not connected, access only granted with service key inserted!
Configuration of the optional cutter. See documentation of the cutter.
If cutter is not connected, access only granted with service key inserted!
Configuration of the optional applicator. See documentation of the applicator.
If applicator is not connected, access only granted with service key inserted!
Brightness of the LCD display from 1 to 10
Contrast of the LCD display from 4 to 8.
Time between the last operation and the activation of Powersave mode.
Operating mode which supports the firmware programmer when localizing
errors.
Configuration Instructions
Default
0.0 mm
0.0 mm
0.0 mm
10
6
5 min.
Off
Edition 3/07