Basic Operations; Turning The System On/Off - JVC TH-SW8 Instructions Manual

Basic operations

The buttons on the remote control are used to explain most of the
operations in this manual. You can use the buttons on the center
unit same as on the remote control for operations unless
otherwise noted.
IMPORTANT
Before using the remote control for the following
operation;
• Set the remote control mode selector to AUDIO.
The buttons described below are used on
pages 17 to 20.
MUTING
DVD FM/AM
Source
selecting
buttons
Cursor
(3/2/Y/5)/
ENTER
SLEEP DIMMER
S.WFR CENTER
STANDBY/ON
lamp
17
F AUDIO
AUX TV SOUND
AUDIO VOL
AUDIO Remote control
mode selector
ENTER
SCAN MODE
TREBLE
SMART
S.SETUP
L-SURR.-R
STANDBY
PHONES

Turning the system on/off

On the remote control:
Press F AUDIO.
On the center unit:
Press F.
When DVD is selected as the source (A pg. 18), the following
messages will appear on the TV screen.
• "OPEN"/"CLOSE":
Appears when opening or closing the disc tray.
• "NOW READING":
Appears when the system is reading the disc information.
• "REGION CODE ERROR!":
Appears when the Region Code of the DVD VIDEO does not
match the code the system supports. The disc cannot be
played back.
• "NO DISC":
Appears when no disc is loaded.
• "CANNOT PLAY THIS DISC":
Appears when unplayable disc is loaded.
NOTE
• Both the STANDBY and STANDBY/ON lamps turn on when the
power is turned off and turns off when the power is turned on.
• The power supply to the subwoofer is linked to the center unit. The
POWER ON lamp on the subwoofer lights green when the power is
turned on.
• When the wireless receiver unit does not receive any radio wave for
approximately 10 minutes, the unit automatically turns off.
• Even though the wireless receiver unit is turned off, the unit
automatically turns on by receiving the radio wave from the center
unit.
• A small amount of the power is consumed even when the power is
turned off (center unit only). This is called standby mode and the
STANDBY lamp lights in this mode. Unplug the power cord from the
AC outlet to turn the power off completely.
• You can also turn on the system by pressing the following buttons;
OPEN/CLOSE on the remote control or 0 on the center unit
•
One of the source selecting buttons on the remote control
•
3 on the center unit. You can use the same buttons on the remote
•
control except after pressing FM/AM.
VOLUME