Optimizing The Speaker Settings [Smart Surround Setup] - JVC TH-SW8 Instructions Manual

Basic operations
Optimizing the speaker
settings [Smart Surround
Setup]
Be sure to connect the surround speakers to the powered
subwoofer before performing Smart Surround Setup
function. (A pg. 10 or 11)
NOTE
• When you change the positioning of the speakers or listener, or
replace the supplied speakers with other ones, perform Smart
Surround Setup again.
• Before you start the following procedure, be sure to change the
(A
WRLS SP setting to OFF.
completed, be sure to change the setting back to ON when you use the
wireless receiver unit.
7 While DVD is selected as the source and stopped
1
Take your position where you listen to
the sound.
2
Press and hold SMART S.SETUP.
"SETTING UP" flashes on the display window.
3
Press ENTER, press Cursor Y/5 to
select the distance between the front
speakers and the listening position,
then press ENTER.
4
Press Cursor Y/5 to select START,
then press ENTER.
5
Clap your hands over your head once.
6
Make sure that "COMPLETED !"
appears on the TV screen, then press
SMART S.SETUP.
The system detects your clapping sound through the satellite
speakers, then automatically makes the best settings for each
speaker. "COMPLETED !" appears on the TV screen when
Smart Surround Setup completes.
pg. 36) After the procedure is
When "FAILED !" appears on the TV screen
The system could not detect the clapping sound correctly. In such a
case, follow the instructions that appears on the TV screen.
• When the system detects the clapping sound as "FAILED !" three
times, set the distance (DISTANCE) and the output level
(LEVEL) manually (A pg. 38).
To cancel
Press SMART S.SETUP.
NOTE
• You need to set the subwoofer's output level (LEVEL) manually.
(A pg. 19 and 38)
• In step 2, "SW ERROR" appears on the display window if the center
unit and the powered subwoofer are not connected correctly by using
the supplied system cord.
See page 17 for button locations.
20