Assembling The Front And Surround Speakers - JVC TH-SW8 Instructions Manual

Connections
Assembling the front and
surround speakers
The following procedure explains the front speaker assembly. The
assembly of both the front and surround speakers are done in the
same manner.
Front speaker Surround speaker
(×2)
NOTE
• The stands and the base plates are commonly used for both front and
surround speakers assembly.
Before assembling —
• Prepare a Phillips screwdriver (not supplied).
• Take care not to drop the base plate while assembling; otherwise,
it may cause damage to the floor or injury.
1
Stand
Base plate
Bottom
• You can route the speaker cords through one of the three
grooves on the base plate depending on the speaker layout.
• Depending on the installing condition, you can assemble the
front and surround speakers without the stands. In such a
case, attach the speaker directly to the base plate instead of
the stand.
9
Stand (×4)
(×2)
Base plate (×4)
Speaker cord
(supplied)
This page is for
2
Black
Screw M5 x 25 mm (supplied)
3
Speaker
Stand
Completion
with stand
Red
Copper
Silver
Black
White
Screw M5 x 25 mm
(supplied)
without stand