Basic Operations; Turning The System On/Off - JVC TH-P7 Instructions Manual

Basic operations

The buttons on the remote control are used to explain
most of the operations in this manual. You can use the
buttons on the center unit same as on the remote control
for operations unless otherwise noted.
The buttons described below are used on pages 15 to
17.
15

Turning the system on/off

On the remote control:
Press AUDIO.
On the center unit:
Press .
When DVD or USB MEMORY is selected as the source (see
page 16), the following messages will appear on the TV
screen.
• "OPEN"/"CLOSE":
Appears when opening or closing the disc tray.
• "NOW READING":
Appears when the system is reading the disc/file
information.
• "REGION CODE ERROR!":
Appears when the Region Code of the DVD VIDEO
does not match the code the system supports. The
disc cannot be played back.
• "NO DISC":
Appears when no disc is loaded.
• "NO USB DEVICE":
Appears when no USB mass storage class device is
connected.
• "CANNOT PLAY THIS DISC":
Appears when unplayable disc is loaded.
• "CANNOT PLAY THIS DEVICE":
Appears when unplayable USB mass storage class
device is connected.
NOTE
• The STANDBY lamp goes off when the power is turned on,
and the lamp lights when the power is turned off.
• A small amount of power is consumed even when the power
is turned off. This is called standby mode and the STANDBY
lamp lights in this mode. Unplug the power cord from the
AC outlet to turn the power off completely.
• You can also turn on the system by pressing the following
buttons;
– 0 on the center unit
– One of the source selecting buttons on the remote control
– 3 on the center unit.