Bernina artista 200 Owner's Workbook page 88

M
ASTERING
Y
OUR
BERNINA
®
• Fabric strips should be cut 1¼" plus the circumference of the cord being used.
• Trim the 2" strip, if needed, to work with the cording being used. This should result in
5
a / " seam, once the piping is made.
8
Note: Strips should be cut on the bias; however, crosswise and lengthwise
strips may be used if there are no corners to be turned or curves to maneuver.
• Fold the wrong side of the fabric around the filler cord and position it under the presser
foot with the folded edge to the left and the cord under the center of the foot so it rides
in the large groove.
• Using a straight stitch and with the needle in one of the right positions, begin stitching.
The stitches will be alongside the cord, creating a
• Once the piping is made, it is ready to be inserted into a seam.
• Cut the other fabric piece in half, making two 2" x 6" pieces.
• Insert the piping using the same foot, but before stitching adjust the needle one position
closer to the center needle position. Note: By adjusting the needle position, the previous
stitching will not be seen on the finished project.
BERNINA
M Y
ASTERING OUR
PIPED PORTIONS
Fabric:
Needle:
Thread:
Presser Foot:
®
8/15/02
BERNINA
Firmly woven - 6" x 4"
Cotton - 2" x 15"
Cable Cord - 18"
90/14 Universal
All-Purpose
Bulky Overlock Foot #12/12C
5 / " seam.
8
S E
ECTION
®
artista 200
artista 200/88