Finish Projector Drop Ceiling Mount Installation - Extron electronics PVS 405D Installation Manual

Polevault digital switcher systems

Hide thumbs Also See for PVS 405D:

Table of Contents

6. Finish Projector Drop Ceiling Mount

Installation.

a. Detach the projector bracket and projector

from the adjuster plate. DO NOT remove the

projector bracket from the projector.

b. Unscrew the adjuster plate from the mounting

pole.

c. Loosen the pipe adapter set screws on the

PCM 340 and the pipe location screw and

remove the mounting pole, then loosen the

T-frame securing screws and remove the PCM

340 from its marked location.

d. Replace the cut ceiling tile, checking the

orientation to align the hole with the

PCM 340.

e. Replace the PCM 340 over the ceiling tile, slide

the slotted pipe up through the tile and into

the adapter plate. Realign the location holes

with the pipe holes, insert and tighten down the

location screw. Tighten the set screws.

Tighten the four T-frame securing screws on the

PCM 340. The T-frame securing screws can be

used on either side of the frame.

into the pipe adapter plate. Shown as viewed

from below.

PoleVault Digital Systems • Installation — Stage 1 (Screen and Projector)

Slide the pipe up through the ceiling tile and

Table of Contents