Polevault System (Pmk 560 Pole Mount Kit); A1. Install The Pmk 560 Base Plate - Extron electronics PVS 405D Installation Manual

A. PoleVault System (PMK 560 Pole Mount Kit)
Mounting Plate
Where it goes: Attaches to slotted pipe, above the projector and close to the drop ceiling.
•
What it does: Supports and hides the installed PVS 405D switcher and power supply from view.
•

A1. Install the PMK 560 Base Plate.

a. Remove the four cover screws from the center
of the PMK 560 and slide the two halves apart.
Remove them from the base plate.
NOTE: If the PoleVault switcher and its power
supply are already installed, go directly to
step 1d.
b. To mount the PoleVault switcher, place the
mounting plate, with the raised tabs upwards,
on the top surface of the switcher and pass the
two supplied 4-40 x 3/16 inch screws into the
top of the switcher (see figure at right). Secure
the mounting plate but do not overtighten.
Use only the supplied screws to avoid
damaging the switcher.
c. Attach the associated power supply to the base
plate with the supplied tie wraps by passing
them through the appropriate slots and around
the power supply. Tighten until snug
d. Loosen the four pipe collar set screws and slide
the base plate up the pipe until it is touching the
suspended ceiling.
e. Level the base plate and secure it by fully
tightening the set screws.
NOTE:
At least three set screws must come in contact with the pipe.
40 PoleVault Digital Systems • Installation — Stage 4 (PMK 560 and PVS 405D)
Base Plate
To open, remove 4 cover screws
and slide the covers away.
PMK Covers (2)
1d
Attach PMK to the projector
pole. Secure the pipe collar
with the four
10-32 set screws.
1f
Hook the combined mounting
plate and switcher into the
base plate and secure with
screws.
1b
Attach the mounting plate
to the top of the
PoleVault switcher.
PVS 405D
Switcher
Å
Attach the mounting plate to the switcher,
fasten the power supply to the base plate,
the base plate to the projector pole,
mounting plate tabs into the base plate.
1e
IN P U
PO
12 W ER TS
V
3A
M AX 1 /2
SI G O U
TP
U T
LI NK 3 /4
SI G A U
D IO
LI NK L O U
T
P V H D
T IN M I R PA
G IN
S E G
N S P V
P V O R
T IN S 4
0 5
IN P U S A
L T 5 IP
+V
R
A U V O
X IC
E LI
FT
A M
P LI
DO FI E
GR NO D
OR OU T A U
SH ND D IO
SP OR
O V OU EA KE T L O U
TP R 4/ 8 T
E R UT
P V S R
T
IR R E
M O
RS TE
-2 32 LA
S N
G 1
Tx
Rx
G
°
1c
Attach
Power
Supply
Projector
Pole
LA
N
2
LA
N
3
û
ü
secure
and hook