DFI-ITOX NP100-N16C User Manual page 79

Soft-Off by PWR-BTTN
This field allows you to select the method of powering off your system.
Delay 4 Sec.
Regardless of whether the Power Management function is enabled or disabled,
if the power button is pushed and released in less than 4 sec, the system en-
ters the Suspend mode. The purpose of this function is to prevent the system
from powering off in case you accidentally "hit" or pushed the power button.
Push and release again in less than 4 sec to restore. Pushing the power but-
ton for more than 4 seconds will power off the system.
Instant-Off
Pressing and then releasing the power button at once will immediately power
off your system.
Wake-Up By PCI Card
Enabled
This field should be set to Enabled only if your PCI card such as LAN card or
modem card uses the PCI PME (Power Management Event) signal to remotely
wake up the system.
tem to wake up.
Disabled
The system will not wake up despite access to the PCI card.
Wake-Up By Ring
When this field is set to Enabled, the system will power-on to respond to calls
coming from a modem.
USB KB Wake-Up From S3
This field, when enabled, allows you to use a USB keyboard or USB mouse to
wake up a system that is in the S3 (STR - Suspend To RAM) state. This can be
configured only if the "ACPI Suspend Type" field is set to "S3(STR)".
Resume By Alarm
Enabled
When Enabled, you can set the date and time you would like the Soft Power
Down (Soft-Off) PC to power-on in the "Date (of Month) Alarm" and "Time
(hh:mm:ss) Alarm" fields. However, if the system is being accessed by in-
coming calls or the network (Resume On Ring/LAN) prior to the date and
time set in these fields, the system will give priority to the incoming calls or
network.
Disabled
Disables the automatic power-on function. (default)
Access to the LAN card or PCI card will cause the sys-
Refer to the card's documentation for more information.
3
BIOS Setup
79