Power Connector - DFI-ITOX NP100-N16C User Manual

2
Hardware Installation

Power Connector

Connect a 20-pin ATX main power connector from the power supply unit to the
ATX power connector. The system board requires a minimum of 120 Watt power
supply to operate. We recommend that you use a power supply that complies
with the ATX12V Power Supply Design Guide Version 1.1.
Important
The system board consumes a minimal amount of power. Due to its low
power consumption, you only need a 120W to 150W power supply. Every
power supply has its minimum load of power. If you use a greater than
150W power supply, the power consumed by the system board may not
attain its minimum load causing instability to the entire system.
50
1 1
10 20
+12V +5V
5VSB
+5V
PW-OK -5V
GND GND
GND
+5V
GND
GND
PS-ON
+5V
GND GND
3.3V -12V
3.3V 3.3V
1 11