Panasonic DMR-EX75 Operating Instructions Manual page 73

If you need help
PICTURE
No picture.
There is picture interference.
Television reception worsens
when the unit is connected.
The TV picture format is not
set correctly.
No On-Screen messages.
Poor picture in spite
of good signal quality.
SOUND
No sound. Distorted sound.
Volume set to quiet.
It is not possible to hear the
desired sound type.
The sound cannot be set for
stereo or NICAM broadcasts.
REMOTE CONTROL
No functions.
The TV cannot be operated.
DISPLAY
The display light is weak.
"0:00" blinks on the unit display.
External Input
Video or audio is not recorded
from an external unit.
Software Update
When are the software updates
broadcast?
Check the connection to the TV, e.g. AV1.
The PROGRESSIVE output is activated, but the connected TV is not
progressive capable.
Press and hold STOP and
5 seconds. The function is switched to half picture (INTERLACE).
The [TV System] setting does not match that on the disc.
In STOP mode, press and hold STOP
than 5 seconds. This switches the unit from PAL to NTSC or vice versa.
Check the antenna connection and the alignment of your antenna.
You may need to use a signal amplifier.
Check the [TV Aspect] setting in the [Connection] [Setup] menu.
Change the [On-Screen Messages] setting in the [Display] [Setup] menu.
Overmodulation makes the signal strength display go to red.
Readjust the picture with your room aerial until the picture quality improves.
Check the connections.
If you connected an amplifier, check the input mode.
Switch off the V.S.S. function if it causes problems.
Press DISPLAY to select the desired sound type.
Change the appropriate setting in the Sound Setup menu.
The sound cannot be switched on some discs.
Connect external devices with audio cables even if you use a digital connection.
You can change the sound type when using DVD-RAM.
An incorrect remote control code was selected.
Check the batteries.
Point the remote control at the sensor on the unit.
The child lock feature has been activated.
An incorrect remote control code was selected.
Change the [FL Display] setting in the [Display] [Setup] menu.
No time. Set the time in the [Others] [Clock] [Setup] menu.
The external unit is not connected correctly.
The incorrect input channel AV2, AV3, AV4 or DV IN was selected.
The unit shows automatically when a software update has been broadcast, and
also automatically updates the software if thus function has not been switched off
in the [Setup] menu.
PLAY/x1.3 on the unit at the same time for more than
and OPEN/CLOSE
Page
10
19
19
65
on the unit for more
65
64
60
10
71
64
14
6
5
6
6
6
64
67
14
18
67
73