Setup - Panasonic DMR-EX75 Operating Instructions Manual

FUNCTIONS
FUNCTIONS
To Others
Clock
Automatic
Time
Date
10 : 52 : 04 20
Please set the clock.
CHANGE ENTER : access RETURN : leave
ENTER
RETURN
System Update

Setup

EPG Download in Standby
Software Update in Standby
Tuning
EPG / Software search period
Disc
Software Update Search Now
Picture
Sound
Display
Connection SELECT
Others
ENTER
RETURN
System Update
A new software has been found.
Update your software ?
Yes
Setup
SETUP
Others
On
Clock
Clock setting
. 03 . 2006
The clock will normally be set correctly during Auto-Setup however, under certain
circumstances the DVD Recorder cannot set the clock automatically. In this case
follow the operation steps below to manually set the clock.
Switch with
Change with
Confirm the change with ENTER.
Activating the automatic time correction function
The correct time for the clock can be automatically maintained when the DVD Recorder
is tuned to a station that transmits a time signal.
Switch with
The automatic setting of the clock begins.
Under adverse reception conditions, etc., the Automatic time correction function may
not work. In this case the indication for Clock setting is automatically reset to [Off].
If the reception conditions improve later on, it is possible to activate this function.
If the Clock setting is set to [On], do not set it to [Off], otherwise the automatic time
correction function is deactivated.
This DVD Recorder uses a 24-hour-clock.
In the event of a power failure an automatic back-up system maintains the clock for
approximate 60 minutes.
When the Clock setting is set to [On], the automatic time correction function checks
and if necessary adjusts the time several times every day. The automatic time correction
function only works when the DVD Recorder is in standby, it does not work in the Timer
Recording mode.
Don't forget to change summer time and winter time.
System Update
On
EPG Download in Standby
On
Automatic On: EPG data are loaded in standby mode.
Software Update in Standby
The software is automatically updated when the unit is in standby mode. This is
shown in the unit display. If the unit is in standby to record, the timer-controlled
recordings are not affected. If you want to prevent the automatic updates, select the
setting [Software Update in Standby - Off].
EPG / Software search period
[Automatic] [02:00 - 06:00] [06:00 - 10:00] [10:00 - 14:00] [14:00 - 18:00] [18:00 - 22:00] [22:00 - 02:00]
Automatic: The unit looks for new software once within 24 hours.
[02:00 - 06:00], etc.: The software search only starts within the set time period. If the
No
setting [EPG Download in Standby] and [Software Update in Standby] is set to [Off],
then the settings [EPG / Software search period] are invalid.
Software Update Search Now
Start the search for new software manually.
A new software version is announced by a message. Do not switch your unit off during
the update. This could result in the loss of data. A message shows that the update has
finished. If a new software version is not going to be broadcast until the next few days,
a corresponding message also appears.
Initialize
Shipping Condition: All settings, except for the security levels with the associated
password and the time settings and the owner ID, are reset to the factory default settings.
Default Settings: All settings, except for the programmed channels, time, country,
language and disc language settings, the security levels including password and the
remote control code and the owner ID, are reset to the factory-default settings.
Setting
automatic mode to [Off] and confirm with ENTER.
and Time and Date.
automatic mode to [On] and confirm with ENTER.
Option
ENTER
[On] [Off]
[On] [Off]
[Automatic]
[Shipping Condition] [Default Settings]
ENTER
67