Installation - Polaroid M402b Repair Manual

M402b MiniPortrait Camera Repair Manual

Installation

1. To replace the X-sync connector:
• Insert the X-sync connector into its locating hole on the back of the front cover.
• Using a Phillips head screw driver, install and tighten the two (2) screws that secure
the X-sync connector to the front cover.
• Using a soldering iron, connect the wires to the X-sync connector pins being careful not
to apply too much heat to the X-sync connector pin.
Overheating the X-sync pin could damage the insulator that
surrounds the X-sync pin causing it to short out to the connector
plate.
2. To replace the X-sync switch:
• Insert the X-sync switch into its locating hole on the back of the front cover.
• Using a Phillips head screw driver, install and tighten the two (2) screws that secure
the X-sync switch to the front cover.
• Using a soldering iron, connect the orange and black wires to the X-sync switch.
3. If applicable, dress the wires as shown in Figure 2-6.
Note: Apply a dab of hot glue to the plastic slots to secure the wires to the front
cover so that they will not interfere with the operation of the shutter plates.
4. Install the front cover assembly (Figure 2-1).
CAUTION
19
Disassembly/Assembly