Instrument Lighting; Headlamp Beam Adjustment; Switches For The Hazard Warning Light System - Skoda 2012 Superb Owner's Manual

Instrument lighting 
ä
First read and observe the introductory information and safety warn-
ings on page 54.
›
Switch on the light.
›
Turn the control dial » Fig. 35 to the desired intensity of the instrument light-
ing.
The illumination intensity of the Information display
ly. It is only possible to adjust the instrument lighting with the control dial if the
light intensity drops below the set value of the light sensor.
Headlamp beam adjustment 
ä
First read and observe the introductory information and safety warn-
ings on page 54.
›
Switch on the light.
›
Turn the control dial » Fig. 36 to the desired width of illumination.
Fig. 35
Dash panel: Instrument lighting
» page 18 is set automatical-
Fig. 36
Dash panel: Lights and Visibility
Settings
The positions correspond approximately to the following vehicle loads:
Front seats occupied, luggage compartment empty.
-
All seats occupied, luggage compartment empty.
1
All seats occupied, luggage compartment laden.
2
Driver seat occupied, luggage compartment laden.
3
CAUTION
Always adjust the headlight range adjustment in such a way that:
it does not dazzle other road users, especially oncoming traffic,
■
and the range is sufficient for safe driving.
■
Note
The Bi-Xenon bulbs adapt automatically to the load and driving state of the vehi-
cle (e.g. speed, accelerating, braking) when the ignition is switched on and when
driving. Vehicles that are equipped with Bi-Xenon headlights do not have a man-
ual headlight range adjustment control.

Switches for the hazard warning light system


ä
First read and observe the introductory information and safety warn-
ings on page 54.
›
Press switch  » Fig. 37 to switch the hazard warning light system on or off.
Fig. 37
Dash panel: Switch for hazard
warning lights
59
Lights and Visibility

£