Optional Part Installation And Confirmation - Oki MC760 Maintenance Manual

Oki Data CONFIDENTIAL
3.5.3 Optional part installation and conirmation
(1) Installation of the optional tray unit (second/ third/ fourth tray/ LCF)
• Fourth tray:not support for Finisher model
Notes!
It is a traditional paper tray for adding paper into MFP.
Second/ third/ fourth tray : 530 pieces of 70kg paper can be set. Using it with a standard
paper cassette and a multi-purpose tray can print 2220 pieces of pages continuously.
LCF : 2000 pieces of 70kg paper can be set. Using it with a standard paper cassette and
a multi-purpose tray can print 2630 pieces of pages continuously.
<second/ third/ fourth tray>
(1)-1. Turn the MFP power to OFF and pull out the power cord from the outlet.
Turn the power off with following the procedure in chapter 3.5.2 [Turn the power
off.].
Notes! • If you turn off the power without properly shutting down, it may cause
damage to the MFP. Please operate the [Shutdown Menu].
• It may cause damage to the MFP, if you install the optional tray with
power ON.
45376001TH Rev.1
(1)-2. Install the optional tray unit to the MFP.
<LCF>
Joint
Note! Because the weight of the MFP body is approximately 50kg, it needs more
than three adults to lift it up.
① Match the tab into the hole in the bottom of the MFP.
② Put the MFP on the optional tray unit slowly.
③ Attach the joint(2 places) to optional tray unit and screw up.
Remove it following the steps 1-2 in reverse order.
Hole in the bottom of the printer
Tab
Joint
Note! When you install two or more optional trays to the MFP, set the optional tray
directly on top of the other optional tray, and then put them on the MFP.
Screw
Joint
Joint
Hole in the bottom
Tab
3. Set up
Screw
Joint
Hole in the bottom of the printer
Tab
Joint
59 /