Oki MC760 Maintenance Manual page 135

Oki Data CONFIDENTIAL
(3) Display "Scanner Maint" as the Scanner Maintenace Menu show below.
Item1 Item2 Item3
Scanner Adjust Scan FBS
Maint Pos
ADF
(Front-side)
ADF
(Back-side)
Adjust ADF
Scan Pos
45376001TH Rev.1
Value
Item4
(Step)
Side Reg. +42 ~ 0
Front Edge +30 ~ -30
Side Reg. +42 ~ 0
Front Edge +30 ~ -40
Back Edge +30 ~ -40
Front Edge +30 ~ -40
Back Edge +30 ~ -40
+30 ~ -30
Default Default Default
value value value
ODA OEL JP
0 0 0 Adjust the scanning start position of main scanning direction when book scanning.
0 0 0 During book scanning, add a value for the basic value (= 5 mm) when reading the
shadow of the front edge of the document.
Adjust in intervals of one step = 4/600 dpi (=0.17 mm).
+21 +21 +21 Adjust the scanning start position of main scanning direction when ADF scanning.
0 0 0 When reading a document from the ADF, add a value for the basic value when reading
the shadow of the front edge of the document. To skip the front edge of the document,
add a negative value.
Increase or decrease the number of motor pulses from detection by the sensor of the
front edge of the media until actual reading starts.
Adjust in intervals of one step = 4/600 dpi (= 0.17 mm).
0 0 0 When reading a document from the ADF, add a value for the basic value when skipping
the back edge of the document. To read the shadow of the back edge of the document,
add a negative value.
Increase or decrease the number of motor pulses from detection by the sensor of the
back edge of the media until actual reading ends.
Adjust in intervals of one step = 4/600 dpi (= 0.17 mm).
0 0 0 When reading a document from the ADF, add a value for the basic value when reading
the shadow of the front edge of the document. To skip the front edge of the document,
add a negative value.
Increase or decrease the number of motor pulses from detection by the sensor of the
front edge of the media until actual reading starts.
Adjust in intervals of one step = 4/600 dpi (= 0.17 mm).
0 0 0 When reading a document from the ADF, add a value for the basic value when skipping
the back edge of the document. To read the shadow of the back edge of the document,
add a negative value.
Increase or decrease the number of motor pulses from detection by the sensor of the
back edge of the media until actual reading ends.
Adjust in intervals of one step = 4/600 dpi (= 0.17 mm).
0 0 0 Set the CIS reading position of the ADF for the focusing standard.
Adjust in intervals of one step = 4/600 dpi (= 0.17 mm). This is correlated to adjustment
of the ADF front edge position.
5. Maintenance Menu
Notes
134 /