Table of Contents
Advertisement
2.19.5
How to temporarily remove all target trails from the display
You may wish to temporarily remove all trails from the display. Trails are removed but
are continued internally.
Control Unit: Press the TRAIL key to show [OFF] in the trail time indication.
Trackball module: Click the trail time indication to display [OFF].
2.19.6
Trail stabilization in true motion
True motion trails may be ground stabilized or sea stabilized. The [Trail time] indica-
tion shows current stabilization as [True-G] or [True-S]. To change the stabilization
mode, open the [SPEED] menu and set [SHIP SPEED] to [BT] (ground stabilization)
or [WT] (sea stabilization). When the stabilization mode is changed, true trails are re-
set. (Relative trails are not reset.)
2.19.7
Target trail attributes on the TRAIL menu
Note: [SUPPRESS TRAIL AROUND OS] is automatically turned on when [OS TRAIL]
is activated. The possible ON/OFF combinations between [OS TRAIL] and [SUP-
PRESS TRAIL AROUND OS] are as shown in the table below.
Setting
OS TRAIL*
SUPPRESS TRAIL
AROUND OS
Remarks
1
*
When activated, [SUPPRESS TRAIL AROUND OS] automatically turns on.
TRAIL GRAD: The afterglow of the target trails can be
shown in a single tone or gradual shading.
Monotone
TRAIL COLOR: The trail color can be selected from
the colors shown in the left figure. This feature is not
available with the IMO or A type.
TRAIL LEVEL: The level (intensity) of the afterglow that
extends from radar targets can be adjusted. The higher
the number the greater the intensity of the afterglow.
OS TRAIL: Show or hide trail for own ship.
SUPPRESS TRAIL AROUND OS: You can prevent the
display of sea clutter in true trails about your ship, to clear
the radar picture.
OFF
1
OFF
No OS trail
2. RADAR, CHART RADAR OPERATION
Gradual shading
(Single)
ON/OFF pairings available
ON
ON
-
(Multi)
OFF
ON
ON
OFF
-
Setting not
possible
2-23
Advertisement
Table of Contents
Troubleshooting
