Dv Dubbing - JVC DR-MH200SE Instructions Manual

EDITING
60
EN

DV Dubbing

You can dub programmes from a camcorder or DV equipment
connected to the unit with a DV cable. The unit's remote control
allows you the limited control of the connected camcorder or DV
equipment functions during dubbing.
NOTES:
●
Use the DV cable VC-VDV 204U for connection.
●
When you connect a PC to the [DV IN] connector, we do not
assure the normal operation of this unit.
Your unit
Camcorder
DV equipment
To [DV IN]
DV cable
(VC-VDV 204U)
(not supplied)
DV connector
The following on-screen display for DV dubbing appears when
ON SCREEN is pressed while the channel has been set to ADVB.
0:00
HDD
00:00:00. 00
FR360
12bit
DV
DV
A
A Remote control switch
To switch between the devices operable by the remote control
unit. The unit is operable when the remote icon (
displayed faces to the left, while the DV device is operable when
the remote icon is facing to the right.
B Auto capture button
Select to start or pause the dubbing. If ENTER is pressed when
the DV device is in the pause condition, preroll editing* where it
is possible to dub with a start time that is highly accurate will be
activated. When the DV device cannot be operated from the unit
(such as in camera mode), proceed with normal recording
(A pg. 35, 38).
* Preroll editing refers to the playback after the DV tape is slightly rewind.
(For DV devices that do not support the –1x speed, the rewinding time
may be longer.)
C Sound monitor switch
For selecting the desired sound format for dubbing.
1
Connect a camcorder or DV equipment to the [DV IN] connector
on the unit's front panel.
2
Press HDD so that the HDD lamp lights up on the unit.
3
Press PR +/– to set the channel to ADVB.
4
Press ON SCREEN.
●
The on-screen display for DV dubbing appears.
5
Press selection keys to select
to display the remote icon (facing to the right) for the DV
equipment.
6
Press REC MODE repeatedly to set the recording mode.
7
Locate the point from where you want to start dubbing, then
stop or pause playback by pressing the following buttons on the
remote control: I, N, O, o, W.
● To play back in slow speed (1/10 of the normal speed), press W
to pause playback, then press O or N.
To play back frame-by-frame, press W to pause playback, then
●
press W repeatedly. Each press of W advances a frame.
● To change the playback direction, press O or N.
8
Press selection keys to select
repeatedly until the desired sound track appears on the TV
screen.
SOUND 1
:
Select this to record the original stereo sound played back on
the connected DV equipment.
SOUND 2
:
Select this to record the dubbed stereo sound played back on
the connected DV equipment.
MIX
:
Select this to record the sound of both ASOUND 1B and
ASOUND 2B.
●
Note that this selection is not available when the source
programme is recorded in 16BIT (48 kHz) mode.
1:00 2:00
DV
GR-DV3500
00:00:00. 00 L – R
SOUND1
JVC GR-DV3500
1 2
DV
B C
, then press ENTER
, then press ENTER
)