Digital Audio Dubbing - JVC DR-MH200SE Instructions Manual

9
Press selection keys to select
ENTER. The dubbing starts.
●
Playback on the external DV equipment and recording on the
unit should start simultaneously.
●
To pause dubbing, press selection keys to select
then press ENTER. Both the unit and the external DV
equipment pause dubbing. Pressing W on the unit also works
the same way.
10
Press selection keys to select
ENTER. Then press o. The DV equipment stops.
11
Press selection keys to select
ENTER.
12
Press o twice on the remote control to stop dubbing.
●
Both the unit and the external DV equipment stop dubbing.
NOTES:
●
Dubbing copyright guarded programmes is not possible.
●
Original DV information such as the recording date and time are
not recorded.
●
The superimposed indication during the operation or dubbing is
not recorded.
●
If the dubbing is paused while the channel is set to ADVB, you
cannot switch channels.
When you dub from DV equipment other than a
camcorder
A Perform step 1 to 4.
B Locate the point from where you want to start dubbing,
then stop on the DV equipment.
●
If you pause the DV equipment in this step, a few
second's still picture will be recorded at the beginning of
the recorded programme.
C Set the input mode to ADV INPUTB on the DV equipment.
●
If you select an input mode other than ADV INPUTB,
unwanted pictures may be recorded at the beginning of
the recorded programme.
D Perform step 9 to 12.
To skip unwanted part of the source picture
Press ENTER to stop both equipment, then press selection keys
to select .
Locate the point where you want to restart dubbing by pressing I,
N, or O, then press o.
Press selection keys to select
restart dubbing.
, then press
,
, then press
, then press
, then press ENTER to

Digital Audio Dubbing

You can dub selected audio from a DVD or Audio CD disc to a
digital audio device.
However, it is not possible to dub copy-protected discs.
●
Turn on the TV and select the AV mode.
●
Slide the TV/CABLE/SAT/DVD switch to DVD.
Example: Dubbing to an MD
Digital audio device
(MD deck, etc.)
Optical cable
(not supplied)
To [DIGITAL
AUDIO OUT
(OPTICAL)]
Player
1
Connect the unit and a digital audio device using either an
optional optical cable or an optional coaxial cable.
2
Place a disc on the unit and load an MD on the connected
digital audio device.
3
Select the audio to be dubbed.
4
Start playback slightly before the actual point from where you
wish to start dubbing.
5
Press W to pause playback.
6
Select the input mode on the connected digital audio device.
7
Press I to start playback on the unit.
8
Start recording on the digital audio device.
9
Stop recording on the digital audio device. Then press o to stop
playback on the unit.
NOTE:
There may be a discrepancy of several seconds between where
you intend editing to start, and where it actually starts.
EDITING
Recorder
Coaxial cable
(not supplied)
To [DIGITAL AUDIO
OUT (COAXIAL)]
Rear of unit
Note for connection:
Remove the protection cap from the
optical cable.
61
EN