Edit To Or From Another Recorder - JVC DR-MH200SE Instructions Manual

Edit To Or From Another Recorder

You can use your unit as the source player or as the recording
deck.
NOTES:
●
When using another recorder as the recording deck, refer to its
instruction manual.
●
It is not possible to dub copy-protected contents. An error
message will appear on the TV screen.
A When using your unit as the source player
TV receiver
Player
21-pin SCART cable
(not supplied)
Recorder
B When using your unit as the recording deck
TV receiver
Recorder
21-pin SCART cable
(not supplied)
Player
Your unit
21-pin SCART cable
(supplied)
Another recorder
Your unit
21-pin SCART
cable (supplied)
Another recorder
●
Slide the TV/CABLE/SAT/DVD switch to DVD.
1
Connect another recorder's 21-pin SCART connector to the
unit's 21-pin SCART connector as illustrated.
A When using your unit as the source player:
^ connect its [L-1 IN/OUT] connector to the recording deck.
B When using your unit as the recording deck:
^ connect its [L-2 IN/DECODER] connector to the source
player.
●
If another recorder is compatible with the Y/C signal:
^ when using your unit as the source player, set
AL-1 OUTPUTB to ASCART S-VIDEOB. (A pg. 64)
^ when using your unit as the recording deck, set
AL-2 SELECTB to AS-VIDEOB. (A pg. 65)
2
When using this unit as the recording deck, press HDD or DVD
to select the recording deck.
3
When using this unit as the recording deck, press PR +/– to
select AL-2B.
●
Set AL-2 SELECTB to AVIDEOB or AS-VIDEOB. (A pg. 65)
4
When using this unit as the recording deck, press REC MODE
repeatedly to set the recording mode.
5
Engage the Play mode of the source player.
6
Engage the Record mode of the recording deck.
7
Stop recording on the recording deck, then stop playback on the
source player.
NOTES:
●
All necessary cables can be obtained from your dealer.
●
For Y/C signal input/output, be sure to use a 21-pin SCART cable
that is compatible with the Y/C signal.
●
When you use this unit as the source player for editing, be sure to
set ASUPERIMPOSEB to AOFFB before starting. (A pg. 72) If you
are using another recorder with S-Video and Audio output
connectors, connect its S-Video and Audio output connectors to
this unit's [S-VIDEO] and [AUDIO] input connectors on the front
panel. Then, set the unit's input mode to AF-1B in step 3, and set
AF-1 INPUTB to AS-VIDEOB. (A pg. 65)
EDITING
63
EN