Others; Changing The Signal System (Ntsc / Pal); Specifications - Stryker 240-020-505 Instructions Manual

Others

Changing the Signal System (NTSC / PAL)

This DVD recorder supports both the NTSC and PAL signal systems.
The signal system can be altered at the TV TYPE item on the SYSTEM(2/2) menu screen, or via the following procedure.
The signal system can be changed even when the monitor is not connected.
Operation Procedure
1.
Set this unit to the Stop mode.
2.
Press and hold the SETUP and STOP buttons simultaneously for approximately 3 seconds.
This changes the signal system. When this is done, the unit will turn off automatically and rebooted.
This product uses partial third-party software.
For information concerning the software used, login via FTP by
inputting the following into the unit and view the readme.txt file:
User: anonymous
Password: None
(If the IP address of the unit is set to 192.168.0.2, FTP
connection can be established by entering ftp://196.168.0.2 in
the address bar of Internet Explorer.)
74

Specifications

Recording format : DVD Video Version 1.1
Disc format : ISO9660-compatible UDF
Recordable media : DVD-R For General Version 2.0
DVD-RW Version 1.1
DVD+R / DVD+RW
Recording signals : Must conform to DVD Video Format
Video Signals
DVI input : T.M.D.S CLOCK
T.M.D.S LINK #0 8bit × 3 (RGB)
Line input : 1.0 V(p-p), 75 unbalanced
Y/C input : Y signal = 1.0 V(p-p), 75 unbalanced
C signal = 0.286 V(p-p), 75 unbalanced (NTSC)
C signal =0.3 V (p-p), 75 unbalanced (PAL)
DVI output : T.M.D.S CLOCK
T.M.D.S LINK #0 8bit × 3 (RGB)
Line output : 1.0 V(p-p), 75 unbalanced
Y/C output : Y signal = 1.0 V(p-p), 75 unbalanced
C signal = 0.286 V(p-p), 75 unbalanced (NTSC)
C signal = 0.3 V(p-p), 75 unbalanced (PAL)
Encoding format : ISO/IEC13818-2 (MPEG-2 video)
Quantization : 8 bit
Sampling rate : 13.5 MHz
Audio Signals
Line input : –8 dBs, 10 k minimum, unbalanced
+4 dBs, high impedance, unbalanced
Line output : –8 dBs, 1 k minimum, unbalanced
Standard level : –20 dBFS
Dynamic range : 85 dB
Recording format : LPCM / DOLBY DIGITAL / MPEG (PAL only)
External Dimensions (Unit: mm)
212
OPERATE
DVD RECORDER
AUDIO
TITLE CHAPTER
CH1 DOLBY DIGITAL
LPCM MPEG
CH2
PHONES REV STOP PLAY FWD
Quantization : 16 bit
Sampling rate : 48 kHz
Number of channels: 2
DV Interface
I/O : IEEE1394
General
FOOT SWITCH terminal : 3.5 mm Monaural mini jack (OPEN/SHORT
control, Operation follows menu settings.)
Network terminal : RJ-45 (Category5),
100 BASE-Tx
USB terminal : USB 1.1 × 2
Power supply : AC 100V to 240 V
Power consumption : 1.0 A to 0.45 A
Weight : 4.8 k (device only)
Dimensions : 212 mm (w) × 352 mm (d) × 88 mm (h)
(not including feet and other protrusions)
Permissible operating temperature : 5°C to 35°C
Permissible operating humidity : 20% to 80% RH
Permissible storage temperature : –20°C to 60°C
Permissible storage humidity : 5% to 80% RH
Accessories
Instruction manual ................................................................ ×1
Power cord ........................................................................... ×3
Ferrite core (for USB cable) ................................................. ×1
(☞ Page 23)
DVI-HDMI cable ................................................................... ×2
Cable clamp (for DVI-HDMI cable) ....................................... ×1
(☞ Page 13)
SDSP3
SDSP3
88 6.5
BUSY
OPEN/CLOSE
OPTION DV Y/C LINE
SET UP
SET
PAUSE REC TOP
MENU MENU
* Design and specifications are subject to change without notice.
, 50 Hz / 60 Hz
75